Severity Medium
B2246

Passenger Sliding Door Ajar Circuit Short to Ground

📅 Last reviewed: July 2026
What does the B2246 code mean?

The B2246 code indicates that the vehicle's control module has detected a short to ground in the passenger sliding door ajar circuit. This circuit monitors the door position via a switch or limit sensor that changes electrical state when the door opens or closes. A short to ground means the signal wire is contacting chassis ground, causing the module to permanently interpret the door as open or generate an invalid signal. This code falls under the body and convenience category of OBD-II codes.

Medium
Severity
Variable
Typical Cost
Medium
Frequency

1. Commonly Affected Makes

Grupo FCA/Stellantis

2. Most Common Causes

3. Symptoms You Will Notice

4. Step-by-Step Diagnosis

1

Scan for codes and verify B2246 is present

2

Visually inspect the sliding door ajar switch and connector for damage or corrosion

3

Check the signal wire for continuity to ground using a multimeter

4

Disconnect the switch and see if the short clears; if so, replace the switch

5

Inspect the wiring harness for chafing or pinched wires near the door hinge area

6

If wiring and switch are good, test the BCM input/output; replace BCM if faulty

5. Frequently Asked Questions

Is it safe to drive?

Yes, it is generally safe to drive, but the door ajar warning may be annoying and interior lights may stay on, draining the battery. The power sliding door may not function properly.

How much does it cost to fix?

Repair costs typically range from $100 to $400, depending on the cause. A switch replacement is on the lower end, while BCM replacement can be higher.

6. Related Codes

Need an OBD2 Scanner for the B2246? Compare the best scanners compatible with all vehicles
🛒 View OBD2 Scanners →