Severity High
P2513

Event Data Recorder Request Circuit Low

📅 Last reviewed: July 2026
What does the P2513 code mean?

The P2513 code indicates that the Powertrain Control Module (PCM) has detected a low voltage condition in the Event Data Recorder (EDR) request circuit. This circuit is used by the PCM to communicate with the EDR module, which records vehicle data during crash events. A low voltage signal suggests a short to ground, open circuit, or faulty component in the wiring or connectors between the PCM and EDR module.

High
Severity
$50-$150
Typical Cost
High
Frequency

1. Most Common Causes

2. Symptoms You Will Notice

3. Step-by-Step Diagnosis

1

Step 1: Use a scan tool to retrieve all stored codes and freeze frame data.

2

Step 2: Visually inspect the EDR request circuit wiring and connectors for damage, corrosion, or loose connections.

3

Step 3: With key on engine off, measure voltage at the EDR module connector on the request circuit. Expected voltage is near battery voltage (12V). If low, check for shorts or opens.

4

Step 4: Disconnect the PCM and EDR module, check continuity and resistance of the circuit. Repair or replace as needed.

5

Step 5: If wiring is okay, replace the EDR module and clear codes. Test drive to verify repair.

4. Frequently Asked Questions

Is it safe to drive with this code?

Yes, the vehicle is generally safe to drive as the code does not affect engine or transmission performance. However, the EDR may not record data in a crash, which could be important for insurance or legal purposes.

How much does it cost to fix?

The cost typically ranges from $50 to $150 for diagnosis and repair, depending on the cause. If the EDR module needs replacement, parts can add $100-$300.

5. Commonly Affected Makes

This is a generic OBD2 code, potentially applicable to any manufacturer using this diagnostic standard.

6. Related Codes

Need an OBD2 Scanner for the P2513? Compare the best scanners compatible with all vehicles
🛒 View OBD2 Scanners →