Severity Medium
P0288

Cylinder 10 Injector Circuit Low

📅 Last reviewed: July 2026
What does the P0288 code mean?

The P0288 code indicates that the powertrain control module (PCM) has detected a low voltage or resistance condition in the electrical circuit of the fuel injector for cylinder 10. This typically means the injector circuit is drawing less current than expected, often due to a short to ground, open circuit, or a faulty injector. The PCM monitors the injector driver circuit and sets this code when the voltage is below the specified threshold, which can lead to reduced fuel delivery and engine performance issues.

Medium
Severity
$150-$400
Typical Cost
Medium
Frequency

1. Most Common Causes

2. Symptoms You Will Notice

3. Step-by-Step Diagnosis

1

Step 1: Use a scan tool to confirm the code and check for additional codes.

2

Step 2: Visually inspect the wiring and connector for cylinder 10 injector for damage, corrosion, or loose connections.

3

Step 3: Measure resistance of the injector; should be within spec (typically 12-16 ohms).

4

Step 4: Check for voltage at the injector connector with key on; should see battery voltage on one pin.

5

Step 5: Perform a continuity test from the injector connector to the PCM to rule out open or short circuits.

4. Frequently Asked Questions

Is it safe to drive with this code?

It is not recommended to drive with this code as it can cause engine misfire, reduced performance, and potential damage to the catalytic converter.

How much does it cost to fix?

The cost typically ranges from $150 to $400, depending on whether the injector needs replacement or if it's a wiring repair.

5. Commonly Affected Makes

This is a generic OBD2 code, potentially applicable to any manufacturer using this diagnostic standard.

6. Related Codes

Need an OBD2 Scanner for the P0288? Compare the best scanners compatible with all vehicles
🛒 View OBD2 Scanners →