B1410: Driver Window Motor Circuit Failure
The B1410 code indicates that the Body Control Module (BCM) or Driver Door Module (DDM) has detected a fault in the driver's power window motor circuit. This typically means an open circuit, a short to ground, a short to battery voltage, or an internal motor failure preventing normal operation.
1. Commonly Affected Makes
2. Most Common Causes
- Faulty driver window motor (open or shorted internally)
- Damaged, corroded, or disconnected wiring in the door harness (especially at the hinge area)
- Loose, bent, or corroded pins at the motor or door module (DDM/BCM) connector
- Internal failure of the Driver Door Module (DDM) or BCM
- Blown fuse or defective relay in the power window system
- Mechanically stuck window regulator or glass out of track causing excessive current draw
3. Symptoms You Will Notice
- Driver window does not move or moves intermittently
- Window moves slowly or erratically
- Window may only work from one switch (master or door)
- Other windows may still operate normally
4. Step-by-Step Diagnosis
Check for blown fuses and test the window relay.
Inspect the door harness and connector at the hinge for breaks or corrosion.
Test the window motor by applying direct battery power and ground; if it doesn't run, replace the motor.
Check for voltage and ground at the motor connector with the switch pressed; if missing, suspect DDM/BCM or wiring issue.
If motor runs on direct power but not through the module, test the DDM/BCM outputs and replace if faulty.
5. Frequently Asked Questions
Is it safe to drive?▼
Yes, it is generally safe to drive, but the driver window may not operate. Avoid driving in conditions where you need to open/close the window frequently.
How much does it cost to fix?▼
Repair costs range from $100 to $400 depending on the cause. A window motor replacement typically costs $150-$300, while a DDM or BCM replacement can be $200-$400.